Chapter 9 Functions
9-77
9.5.2 Position Override
This is used to change the goal position during positioning operation by positioning data.
(1) Characteristics of Control
(a) Position override command is used in the operation pattern (Acceleration, Constant speed, Deceleration
section) and the available operation mode is End operation, Go-on operation, Continuous operation.
(b) Position setting range is –2,147,483,648 2∼ ,147,483,647 Pulse.
(c) As the operation is different according to Position Override command during operation, cares should be
taken in using.
In other words, if position of position override at the moment of commanding position override is bigger than
the position it stopped at, the positioning direction would be forward. If it is smaller, the direction would be
reverse.
(d) This command may be executed several times in operation.
(2) Operation timing
If position override is executed in operation, the goal position is changed to override position1 and keep
operating. If position override for override position2 is executed at dec. area, positioning is finished by acc.
speed already set at override position2.
To Next Page
Loading...
