Chapter 8 Program
8-57
(d) Address of Positioning Module
In this example, Positioning Module is installed at the 3 slot.
(e) Axis of command execution
You can set an axis for Inching Operation. XBF-PD02A supports for 2 axes. In the “execution of axis”, you
can set a value 0 (Axis X) or 1 (Axis Y).
(g) State of Operation complete
If function block is completed without error, “1” will be outputted and maintain “1” until the next operation. If
error occurred, “0” will be outputted.
(h) Error State
This is the area that output error no. if there are errors in operation of function block.
(i) For more information, reference for Homing is in the “Chapter 9.1.”
To Next Page
Loading...
