Chapter 9 Functions
9-83
(2) Operation timing
(3) Restrictions
In the cases below, positioning speed override is not executed and previous operation is being kept.
(a) Current operation is not positioning (shortcut position control, Inching operation) control. (error code:382)
(b) The value of speed override exceeds speed limit of basic parameter. (error code:383)
The speed value of speed override must be below speed limit.
(c) Execute positioning speed override on the sub axis of linear interpolation. (error code:384)
In linear interpolation, positioning speed override must be executed on main axis.
(d) Execute speed override on the sub axis of circular interpolation. (error code:385)
In circular interpolation, positioning speed override must be executed on main axis.’
(e) Execute speed override on sub axis of sync. operation. (error code:386)
(f) If execute positioning speed override in dec. area., error code 377 arise and speed overrid is not executed.
To Next Page
Loading...
