Page 10 of 237
Version: 5.1.6 – June 4
th
, 2019
Chapter 25. Firmware update directly via USB: Additional information.
Chapter 25. Firmware update directly via USB: error correction
“…until LED FC3 flashes…” is wrong, it has to be Fc2.
In chapter 19.1 Security > Firewall General the function SNAT (WAN) has been added.
Correction of the description in chapters 19.2 - 19.4 "Input of ranges" in the input fields for
IP addresses and "Input of ranges or enumerations" in the input fields for ports.
Updating the company logo
3. Safety Instructions (English and France)
Only qualified specialist personnel may install, start up, and operate the router. The national safety and
accident prevention regulations must be observed.
The router is built to the latest technological standards and recognized safety standards (see Declara-
tion of Conformity).
The router is only intended for operation in the control cabinet and with SELV according to IEC
60950/EN 60950/VDE 0805.
The router is for indoor use only.
Never open the router chassis. Unauthorized opening and improper repair can pose a danger to the
user. Unauthorized modifications are not covered by the manufacturer’s warranty
Opening up the device voids the warranty!
The router must be disposed of in line with European regulations and German legislation on elec-
tronics and electronic device (WEEE), and not as general household waste
The router may only be connected to devices, which meet the requirements of EN 60950.
ADVICE:
The unit should be connected and operated on a telephone switchboard only. The unit is not intended
to be direct connected to a public telephone system.
NOTE:
Electrostatic discharge!
Observe the necessary safety precautions when handling components that are vulnerable to
electrostatic discharge (EN 61340-5-1 and IEC 61340-5-1)!
To Next Page
Loading...
Need help?
General
