Page 24 of 237
Version: 5.1.6 – June 4
th
, 2019
Connecting the router to a configuration PC
Before configuring the router, connect it to the computer using the
crossover cable supplied (1). To do this, connect one end of the ca-
ble to the router port labeled LAN, and the other end to your com-
puter’s network card.
10. Router configuration prerequisites
a PC with a network card
an Internet browser (HTML5-compatibility)
The required settings on your PC are as follows:
o the computer’s IP address must be set to
192.168.0.X where X is variable
o the subnet mask must be 255.255.255.0
For instructions on how to create the required settings on a PC, please see the next page. If you
already know how to set the IP address and subnet mask, set them as described above and then
proceed with configuration as described in
Initial Configuration
To Next Page
Loading...
Need help?
General
