MB Connect Line mbNET Series - Lan > Wan

Page 158 of 237
Version: 5.1.6 – June 4
th
, 2019
LAN > WAN
This setting governs the outgoing data traffic, i.e. the following settings only apply to outgoing data
traffic.
Label
Description
Enable
Check the box by clicking it to enable the subsequent settings after they are saved.
Action
The following options are available for selection:
 Drop
If this option is selected, it means that no data packets can pass. The sender is not
notified about the whereabouts of the data packets.
 Reject
If this option is selected, the data packets are rejected. The sender is notified that the
data packets have been rejected.
 Accept
If this option is selected, the data packets can pass.
LAN Interface
Use this selection field to specify the LAN interface to which the rule is to be applied.
You can choose from:
 local Services
 LAN Ethernet
 all
Source IP
Enter the IP addresses of the computers from which data packets are sent to the Internet
(gateway). If you leave the field blank, the set action applies to all IP addresses.
Source Port
Enter the ports via which the data packets go to the Internet here.
Protocol
The following options are available for selection:
 All - the set rule applies to all protocols.
 tcp - the set rule only applies to the TCP protocol.
 udp - the set rule only applies to the UDP protocol.
 icmp - the set rule only applies to the ICMP protocol (ping).
WAN Interface
This setting defines the WAN interface to which the rule is to be applied.
 Internet
 WAN Ethernet
 OpenVPN
 IPSecVPN
 PPTPVPN
 all
Destination IP
Enter the destination addresses of the data packets on the Internet here.