MB Connect Line mbNET Series User Manual

Page 157 of 237
Version: 5.1.6 – June 4
th
, 2018
Source IP
Here, enter the IP addresses for whose incoming data packets one of the set actions is to
be executed.
If you leave the field blank, the set action applies to all IP addresses (only on the selected
interface).
Source Port
Enter the ports via which the data packets arrive here.
Protocol
The following options are available for selection:
 All - the set rule applies to all protocols.
 tcp - the set rule only applies to the TCP protocol.
 udp - the set rule only applies to the UDP protocol.
 icmp - the set rule only applies to the ICMP protocol.
LAN Interface
Use this selection field to specify the LAN interface to which the rule is to be applied.
You can choose from:
 local Services
 LAN Ethernet
 all
Destination IP
Enter the IP addresses to which the data packets are to be forwarded here.
Destination Port
Enter the ports via which the data packets are forwarded here.
Accepts a new rule.
Deletes entries in the current line.
Edits the settings in the current line.
Temporarily saves the created rule.
Changes the order of the created rules.
ADVICE
You can enter address ranges in the input fields for the IP address.
Example of address ranges: 192.168.0.100-192.168.0.110 or 192.168.0.20/30
Address listings are not possible!
In the input fields for the ports, you can enter ranges or enumerations.
Example of a port range: 502-504
Example of port enumeration: 502,677,555
Both, range and enumeration can not be used simultaneously in the same field.
Ranges must be separated by a hyphen (-) and enumerated by comma (,).
No spaces between the elements to be separated!
The input of IP and port is not mandatory. If neither an IP nor a port is specified, a rule applies only to the selected
interfaces.

MB Connect Line mbNET Series Specifications

General

Brand	MB Connect Line
Model	mbNET Series
Category	Network Router
Language	English