Page 228 of 237
Version: 5.1.6 – June 4
th
, 2019
27. Factory settings on delivery
Username and password
The router is shipped with the following username and password:
Username: admin
Password: No password required
IP address of the router
The router is set to the following IP address in the factory:
IP address: 192.168.0.100
28. Loading the factory settings
Follow the steps outlined below to reset the industrial router to the factory settings:
IMPORTANT: You should first back up your configuration. Once you have carried out these steps, your pre-
vious settings will no longer be available.
1. Switch on the device
2. Wait until the Rdy LED blinks
3. Press and hold the dial-out button until the Fc4 / TxD2 LED lights up
4. Press the dial-out button again (Fc3 / RxD2 lights up)
5. Press the dial-out button again (Fc2 / TxD1 lights up)
6. Finally press the dial-out button one last time
The custom configuration is then deleted. The industrial router is reset to the factory settings and can be
reconfigured.
IMPORTANT: The IP address of the industrial router is reset to 192.168.0.100. The computer’s network set-
tings must be changed accordingly.
To Next Page
Loading...
Need help?
General
