Driver from list: Select a product/brand-specific driver to control your serial device.
User settings: If no suitable driver is available or you need to enter your own configuration pa-
rameters. These can be entered manually.
Baud rate: Enter the baud rate for communication here.
Data format: Select one of the settings for data bits, parity or stop bits
Handshake: Select a handshake (flow control) option.
Receive loops: This is a start counter for serial signals, i.e. how many cycles the
system goes through until it sends the data packet.
Select the driver that you want to load. Device drivers can be selected for the following brands:
AllanBradley, AMK, ASB, AtlasCopco, AVAT, Baumüller, Berger, Bosch, B&R, DanfossVLT,
Elau, F-Tron, GE_Fanuc, Hitachi, I-for-T, Indramal, IQ2000, KEB, Kuhnke, Lauer, Lenze, Locon,
Micro Innovation, Mitshubishi, Möller, Motoman, Npos, Omron, Parker Hauser CompaxC3, Phoenix,
Pilz, PLC Direct, Primo, Proface, Promicon, Quin, SCS Automata, Seidel Kollmorgen, SEW,
Siemens, Stoeber, Stromag, Sütron, Tsx37, Tsx47, Tsx57, Vectron, Vega Sensor, Voelkel Grenzlastreg-
ler, Winloc
To Next Page
Loading...
Need help?
General
