Page 74 of 237
Version: 5.1.6 – June 4
th
, 2019
To enable the connection, check the box by clicking on it.
If you select “yes” here, the PPTP server will be configured using the mbNET’s LAN ad-
dress. This setting needs to be tried out first. You should only enter your PPTP server set-
tings manually if there is an address conflict.
Local IP address or Range
Enter any local address in this input field.
In the example it is: 192.168.10.100
Note:
You can also use the router’s LAN IP address. You should only re-host your PPTP server
in a different address space if there is an address conflict.
Remote IP address or
Range
Enter the remote addresses here.
In the example: 192.168.10.160-170
This assigns the IP addresses of the connected clients within the range of 192.168.10.160
– 192.168.10.170.
Important It is essential that the address or address range entered here is in the same
address space as the local IP address chosen above
Give DNS address to the
client
Enter the DNS server address.
In this case: 192.168.0.100 (router IP address)
Use the default setting (MPPE V2 All)
Use the default setting (via CHAP and MS-CHAP V2).
Save your changes by clicking Save Changes.
Finally, to save your changes permanently to the
router, click Apply Changes.
To Next Page
Loading...
Need help?
General
