ix
WARNING
Do not disassemble or remodel the device Handling of the cable
• Never disassemble or remodel the
main unit of the plotter and the
blower unit. Disassembling/remod-
eling any of them will result in
electric shocks or breakdown of the
device.
• Take care not to damage, break or
work on the power cable or com-
munication cable. If a heavy matter
is placed on the power cable, heated
or drawn, the power cable can
break to cause fire or electric
shocks.
Do not use the device in damp places Handling of tools
• Avoid damp environments when
putting the device into service. Do
not splash water onto the device.
High-humidity or water will give
rise to fire, electric shocks or break-
down of the device.
• Store cutter holders or blades in a
place that is out of the reach of chil-
dren. Never place cutter holders or
blades in the tray on the operation
panel.
Abnormal event occurs Preventive measure against dust
• If the device is used under an
abnormal condition where the
device produces smoke or unpleas-
ant smell, fire or electric shocks can
result. Be sure to turn off the power
switch immediately and detach the
plug from the receptacle. Check
first to be sure that the device no
longer produces smoke, and contact
a distributor in your district or
MIMAKI office for repair. Never
repair your device by yourself since
it is very dangerous for you to do
so.
• When handling any dust-producing
substance that will jeopardize the
health of personnel, wear a mask or
the like to prevent dust.
Power supply and voltage Leave maintenance to a serviceman
• Be sure to use the device with the
power supply specifications indi-
cated.
Be sure to connect the plug of the
power cable to a grounded recepta-
cle.
If not, fire or electric shocks can
result.
• Leave maintenance works to a ser-
viceman whenever the device has
broken. Never conduct mainte-
nance works by yourself since the
works are always accompanied by
possible risks of electric shocks,
etc.
To Next Page
Loading...
Need help?
General
