xi
Precautions in installation
CAUTION
A place exposed to direct sunlight A place that vibrates
• Do not install the device at a place
where the temperature of the cut
panel surface exceeds 60°C. The
cut panel can deform or break
down.
• The device will fail to give correct
results if installed in a place that
vibrates.
A place in which temperature and humidity
vary by a great margin
A place filled with dirt, dust or tobacco
smoke
• Use the device under the following
environment.
Operating environment:
10 to 35°C
35 to 75% (Rh)
• The plotter is a precision machine.
Do not use it in a place that is filled
with dirt and dust.
A place exposed to direct air blow from air
conditioner., etc
Near flammable materials
• Cutting quality could be adversely
affected.
• The plotter is a precision machine.
Do not use it in a place that is filled
with dirt and dust.
A plate that is not horizontal
• If the plotter is not leveled, the plot-
ter will fail to give correct results.
Also the tilted plotter can break.
To Next Page
Loading...
Need help?
General
