iv
Register Mark not detected [TOOL Adjust] > [LIGHT POINTER]..................................................3-4
TOOLS ARE NOT ALIGNED TO EACH OTHER [TOOL SELECT] ........................................................3-6
Flowchart of checking and adjusting procedures......................................................................................3-6
General explanation of the adjustment of tools .........................................................................................3-6
Adjustment of the cutter.....................................................................................................................................3-7
Adjustment of the offset.....................................................................................................................................3-9
Adjustment of the roller ..................................................................................................................................3-10
How to adjust the tools....................................................................................................................................3-12
IF THERE IS A SIGN OF FAILURE .....................................................................................................................3-15
The device not at all actuates even when the power to the device is turned on ..........................3-15
The device fails to actuate even when data is transmitted from CAD............................................ 3-15
Error arises when transmitting data ............................................................................................................ 3-15
The tool drags on the sheet of paper...........................................................................................................3-15
Dotted lines or blurred lines are plotted ....................................................................................................3-16
There is no reciprocal vibration....................................................................................................................3-16
TROUBLES FOR WHICH ERROR MESSAGES ARE GIVEN ON THE LCD...................................3-17
Errors that can be corrected by users..........................................................................................................3-17
Errors that cannot be corrected by users ...................................................................................................3-20
CHAPTER4 APPLICATION FUNCTIONS
ASSIGNMENT OF PEN NUMBERS [MODE SET] > [PEN ASIGN].........................................................4-2
RE-CUT OF THE SAME DATA [COPY]...............................................................................................................4-4
SETTING THE NUMBER CUT FUNCTION [MODE SET] > [MULTI-PASS] .....................................4-6
SETTING THE ONE-STROKE CUTTING [MODE SET] > [ONE STROKE] ........................................4-8
SETTING THE DIRECTION OF ROTATION FOR THE COORDINATE AXIS [MODE SET] >
[ROTATE]............................................................................................................................................................................4-9
SETTING THE CUTTER STROKE [MODE SET] > [Z STROKE]...........................................................4-10
SETTING THE UNIT TO BE USED FOR INDICATION [MODE SET] > [UNIT]............................4-11
SETTING THE DUMMY CUT OPERATION OF THE SWIVEL BLADE [MODE SET] > [DUMMY
CUT]....................................................................................................................................................................................4-12
ALIGNMENT OF MECHANICAL AXES TO RULED LINES PRINTED [AXIS ALIGN] ...........4-13
EXPAND THE CUTTING AREA [EXPANDS] ................................................................................................4-15
CHAPTER5 REGISTER MARK DETECT FUNCTION
SETTING OF REGISTER MARK DETECT..........................................................................................................5-2
How to display the register mark setting on LCD ....................................................................................5-2
PRECAUTIONS IN PREPARING DATA WITH REGISTER MARK........................................................5-3
Size of the square mark ......................................................................................................................................5-3
Size of the register mark ....................................................................................................................................5-4
The area where register marks and designs can be arranged ................................................................5-5
No-plotting area around the register marks.................................................................................................5-6
The size of, and the distance between, square marks ..............................................................................5-8
Color of Register mark.......................................................................................................................................5-9
To Next Page
Loading...
Need help?
General
