Minebea Intec PR5900 - Page 130

WP-D R1 Max 1000kg d= 1kg
0
kg
Weighing points @admin
Weighing point A
Weighing point B
Weighing point C
Weighing point D
Internal weighing point
Pendeo Truck
xBPI scale
User scale
Parameters
WP-D R1 Max 1000kg d= 1kg
0
kg
Weighing points @admin
Weighing point D
Settings locked
W&M
Max
Scale interval
Scale Weight /
User scale
none
1000 kg
1
1 kg
Default Save
[Settings locked]
The weighing point settings and assignment can only be viewed as if the
corresponding CAL switch were closed; see Chapter 2.7.1.
[W&M]
Setting for operation in legal metrology.
Selection: [None], OIML, NTEP (for USA) or NSC (for Australia), see Chapter 4.7.1.1.1.
[Max]
Maximum capacity, see Chapter 4.7.1.2.1.1.
[Scale interval]
See Chapter 4.7.1.2.1.2.
[Weight /]
Weight increase per n scale counts.
Setting range: 0.00010…9999999 in t, kg, g, mg, lb or oz.
1. In this case: Select [Weighing point D] with [user scale] and press the [Parameters]
soft key.
A selection window opens.
2. Select and conrm the individual parameters.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-128