Minebea Intec X3 Process Indicator PR 5410 - Page 103

Pin allocation acc. to
DIN 41642
Signal Color acc. to
DIN 47100
Description
1 ---------------------- DO1 yellow not inverted, data output
2 ---------------------- DI1 gray not inverted, data input
3 ---------------------- GND brown signal ground
4 not connected
5 not connected
6 ---------------------- IDO1 green inverted, data output
7 ---------------------- IDI1 pink inverted, data input
8 not connected
9 not connected
* only if necessary
4.6.12.1 LEDs in the module cover
The module cover can be found at the rear of the device.
⑥⑥
LED 1
CC/RC
LED 2
BA
LED 3
RD
LED 4
TR
O
Constant green Cable OK, no reset
mode in the master
Bus is active PCP communication
is active, hold = 500
ms
Constant red Remote bus is not
active
4.6.12.2 Selecting the status LED and transfer rate
LED ⑦ lights up when the operating voltage is applied.
The transfer rate is selected using the 2-pole jumper ④.
- 3 — 1 = 2 Mbit/s
- 4 — 2 = 500 kbit/s
4 Device installation X3 Process Indicator PR 5410
EN-101 Minebea Intec