Minebea Intec X3 Process Indicator PR 5410 - Page 28

Navigation/menu keys
- Cursor to the left
- Selection
Exit - Cancel entry/selection (after a conr-
mation prompt) without saving the ch-
ange.
- Exit parameters/menu window.
- Stop/abort the ongoing lling process.
- Cursor to the right
- Selection
3.4.4.5.1 Selecting parameters
The selection and modication of parameters are described in the following.
1. Press .
SEtuP appears on the display.
2. Press /OK.
The "Cd" calibration menu ashes.
Cd 000 appears on the display.
3. Press to access the next parameter group.
CP ashes on the display.
4. Press to access the parameter number.
CP 010 appears on the display. The right digit ashes.
5. Press / to select the digits.
6. Press / to increase/decrease the number.
7. Press /OK to select the menu item.
The menu item appears on the display.
8. Press /OK to switch to the parameter selection.
9. Press / to select the parameter values.
10. Press /OK to select the parameter values.
11. Press "Exit" to exit a menu.
appears on the display.
If a parameter was changed, SAVE
12. Press /OK.
YES appears on the display.
X3 Process Indicator PR 5410 3 Device description
Minebea Intec EN-26