Minebea Intec X3 Process Indicator PR 5410 - Page 321

SPM address Data type R/W Function
D60 DINT R EasyFill only: Report: Preset
D61 DINT R EasyFill only: Report: Material overshoot (OVS)
D62 DINT R EasyFill only: Report: Calming time [ms]
D63 DINT R EasyFill only: Report: Tolerance below set point
D64 DINT R EasyFill only: Report: Tolerance above set point
D67 DINT R EasyFill only: "Last_Error" error, see Chapter 16.6.2
OPC server only
R264 REAL R Gross weight (as oating point number)
R265 REAL R Net weight (as oating point number)
R266 REAL R Tare weight (as oating point number)
R267 REAL R Current gross/net weight selected with X72 (as oating point
number)
R270 REAL R Max weight (FSD) (as oating point number)
R271 REAL R Min weight (as oating point number)
R272 REAL R Report: Gross weight (as oating point number)
R273 REAL R Report: Net weight (as oating point number)
R274 REAL R Report: Tare weight (as oating point number)
R280 REAL R Standard only: Limit: Limit 1 on (as oating point number)
R281 REAL R Standard only: Limit: Limit 1 o (as oating point number)
R282 REAL R Standard only: Limit: Limit 2 on (as oating point number)
R283 REAL R Standard only: Limit: Limit 2 o (as oating point number)
R284 REAL R Standard only: Limit: Limit 3 on (as oating point number)
R285 REAL R Standard only: Limit: Limit 3 o (as oating point number)
R287 REAL R/W Write the value in the xed tare memory (as oating point num-
ber)
L17
X1088–1151
LWORD
BOOL
W
R
SPM out
Output
L18
X1152–1215
LWORD
BOOL
W
R
SPM out AND coarse
Output and coarse
L19
X1216–1279
LWORD
BOOL
W
R
SPM out AND ne
Output and ne
Note:
The system variables (e.g.: ST_WGT_A) for communication via OPC are described in operating instructions
PR 1792 (Chapter 4 + 5).
13 SPM X3 Process Indicator PR 5410
EN-319 Minebea Intec