Minebea Intec X3 Process Indicator PR 5410 - Page 37

This interface is congurable, and can be used, for example, for data transmission to a
remote display or printer.
Technical data
Description Data
Connection D-Sub female connector, 9-pin
Number of channels 1
Type RS-232, full duplex
Transmission rate [Bit/s] 300 to 115K2 bit/s
Data bits 7/8
Input signal level Logic 1 (high) -3 to -15 V
Logic 0 (low) +3 to +15 V
Output signal level Logic 1 (high) -5 to -15 V
Logic 0 (low) +5 to +15 V
Number of signals Input: RxD, CTS
Output: TxD, RTS
Potential isolation None
Cable type Twisted pair, screened (e.g., LifYCY 3×2×0.20), 1 pair of wi-
res for ground (GND)
Cable gauge
1.5 mm
2
Cable length Max. 15 m
4 Device installation X3 Process Indicator PR 5410
EN-35 Minebea Intec