Minebea Intec X3 Process Indicator PR 5410 - Page 57

- "Slot 1" and "slot 2": PR 5510/02 (see Chapter 4.6.2), PR 5510/04 (see Chapter 4.6.3),
PR 5510/07 (see Chapter 4.6.4), PR 5510/08 (see Chapter 4.6.5), PR 5510/09 (see
Chapter 4.6.6), PR 5510/12 (see Chapter 4.6.9)
- "Slot 4": PR 1721/3x eldbus card (see Chapter 4.6.11, 4.6.12, 4.6.13, 4.6.14, 4.6.15,
4.6.16)
WARNING
Working on the device while it is switched on may have life-threatening
consequences.
Before installing or removing a plug-in card, the device must be disconnected from
all voltage sources.
Note:
After installation/modication, the plug-in cards are detected automatically.
The installed plug-in cards can be displayed via - [Show HW-Slots]; see
Chapter 7.18.3.
4 Device installation X3 Process Indicator PR 5410
EN-55 Minebea Intec