Minebea Intec X3 Process Indicator PR 5410 - Page 67

4.6.3.2.2 RS-485 point-to-point connection (2-wire)
2-wire transfer mode:
Half duplex (simultaneous sending and receiving not possible)
Switch settings Conguration
ON: S1, S2, S3, S4, S5
OFF: …
- [Serial ports parameter]- []- [Slot 1/2 RS485]
Note:
For more information on the switch settings, see Chapter 4.6.3.2.
4 Device installation X3 Process Indicator PR 5410
EN-65 Minebea Intec