Minebea Intec X3 Process Indicator PR 5410 - Page 81

Output circuitry
Voltage output
* The load resistance must be 2.2 kΩ/1 kΩ with 24 V/5 V.
Current output
Recommendation:
* additional external free-wheel diode
** additional internal free-wheel diode, only for very small inductive loads
4.6.5.2 Input
The Enable input for PR 5510/08 (PIN 25) can control the 23 outputs as DATA_IN.
As an output, data is "follow/hold/tristate" and its signal can be congured 5 V (TTL)/24 V
and active-high/active-low.
It is applied to pin 25 (DATA_IN) of the 26-pin connector and is eective only with
switches S101-1 = OFF and S101-2 = ON.
4 Device installation X3 Process Indicator PR 5410
EN-79 Minebea Intec