Output circuitry
Voltage output
* The load resistance must be 2.2 kΩ/1 kΩ with 24 V/5 V.
The internal free-wheel diode is not activated: S101-5 = OFF
Current output
Recommendation:
* additional external free-wheel diode
** additional internal free-wheel diode, only for very small inductive loads
4.6.6.2 Input
The Enable input for PR 5510/09 (PIN 25) can control the 23 outputs as DATA_IN.
As an output, data is "follow/hold/tristate" and its signal can be congured 5 V (TTL)/24 V
and active-high/active-low.
4 Device installation X3 Process Indicator PR 5410
EN-83 Minebea Intec
To Next Page
Loading...