Mobius AIRO Mobile CT System - Transportation Safety; Overview

34 MI-42-0001 Rev. 19
SAFETY: Transportation Safety
2.10 Transportation Safety
2.10.1 Overview
Safety Precautions Follow user instructions.
Cautions and
War
nings
AIRO’s size creates a risk of collision with people and objects. The system is designed to be driven
by trained personnel in an average hospital setting with level floors, low thresholds, standard size
doors and industrial elevators.
Always drive AIRO with the Pendant Display in the holster. Driving with the display out
of the holster creates a danger of both collision and entanglement.
Never allow untrained persons to move or operate AIRO as this creates a hazard of
collision and equipment damage. To avoid the hazard of tipping, observe the following
safety procedures:
- Never push or attempt to move AIRO from the side. Only push using the hand grips on
the system control holster.
- Do not attempt to transport AIRO over damaged flooring.
- Never attempt to transport AIRO with the Ring outside of transport position.
Only attempt to transport or operate AIRO on surfaces and inclines designated as
appropriate for use by the responsible organization following the criteria established
by the manufacturer. Failure to do so creates hazards of collision, tipping, and
equipment damage. AIRO is designed to move on level flooring. Inclines cannot
exceed 5°. Thresholds must not exceed 9.5 mm (3/8 inch).
Transporting objects, devices or material on the operating tabletop is not permitted as
this creates a hazard of equipment damage.
To avoid the potential of serious injury, observe these safety warnings:
- Never transport the system up or down a ramp at an angle. Transporting at an angle on
a ramp creates a hazard of tipping which can cause injury.
- Do not attempt to turn while on an incline or decline. Turning creates a hazard of
tipping which can cause injury.
- Never unlatch the Gimbal while on a ramp. Turning the Ring creates a hazard of tipping
which can cause injury.
- Never disable the main drive wheel while on a ramp. Disabling the main drive wheel
creates a hazard of uncontrolled movement which can cause injury.
- Never store AIRO on a ramp
- Never put AIRO in Scan mode while on a ramp.
- When moving in reverse, users must monitor the route and surrounding area to avoid
colliding into corners, wall, and projections while the system moves toward them.