62 MI-42-0001 Rev. 19
TRANSPORT MODE: Powering Down
3.4 Powering Down
3.4.1 Set to Standby Mode
Overview Whenever AIRO is not in use it should be in Transport position, plugged in, and set to Standby.
How to Enter
Stan
dby Mode
NOTE: Always keep AIRO plugged in to maintain the batteries.
Steps
1. Leave the system with the base up and on its casters.
2. Turn the Ring so it is aligned with the base.
3. Push the Ring toward the middle of the base’s Z-axis until it latches.
4. Plug in the power cord. The green charging indicator light illuminates.
5.
Insert the key and turn it to Standby.
The yellow power indicator light blinks while the PC shuts down.
To Next Page
Loading...