38 MI-42-0001 Rev. 19
SAFETY: Power Failure
NOTE: Scans cannot be performed until main power is restored.
Battery Failure All functions cease if the batteries fully discharge. This is highly unlikely.
NOTE: To protect the batteries when unplugged, AIRO powers down automatically when it has
been unused for one hour.
NOTE: Only qualified service personnel may replace the batteries.
2.12.2 Restoring a Session
General
Information
In the event of a power failure, when power is restored the acquired images will be under Existing
Scans.
What Happens
Wh
en Mains Power
is Restored
AIRO behaves as if it has been turned on normally.
Functions Available
• The table and column function normally, including putting the table into zero position and
releasing it from the column.
• AIRO is transportable using internal battery power (same as normal use).
Battery Failure
1. Plug AIRO into a wall socket to recharge the batteries.
2. If batteries still fail, contact technical support.
Options See
1. Recover data from previous session. 6.8.3 – 6.8.5
2. Re-scan patient. 6.8.6 – 6.8.18
To Next Page
Loading...