Section 1 - Introduction
The purpose of this manual is to assist users in the integration, operation
and maintenance of the E-Multi controller. This manual is designed to cover
most system congurations. If you need additional information specic to your
system please contact your representative or a Mold-Masters oce whose
location can be found in the “Global Support” section.
1.1 Intended Use
The E-Multi controller is an electrical switching device designed for use with
the E-Multi Auxiliary Injection Unit (AIU). It is designed to be safe during
normal operation. Any other uses would fall outside the engineered intent
of this machine which may be a safety hazard and would void any and all
warranties.
This manual is written for use by skilled persons who are familiar with
injection molding machinery and their terminology. Operators should be
familiar with plastic injection molding machines and the controls of such
equipment. Maintenance persons should have sucient understanding of
electrical safety to appreciate the dangers of 3-phase supplies. They should
know how to take appropriate measures to avoid any danger from electrical
supplies.
1.2 Release Details
Table 1-1 Release Details
Document Number Release Date Version
AIU-UM-EN-01-02-11 May 2019 02-11
AIU-UM-EN-01-03 August 2020 03
1.3 Warranty
For current warranty information please refer to the documents available from
our website: https://www.milacron.com/mold-masters-warranty/ or contact
your Mold-Masters representative.
1.4 Returned Goods Policy
Please do not return any parts to Mold-Masters without pre-authorization and
a return authorization number supplied by Mold-Masters.
Our policy is one of continuous improvement and we reserve the right to alter
product specications at any time without giving notice.
1.5 Movement or Resale of Mold-Masters
Products or Systems
This documentation is intended for use in the country of destination for which
the product or system was purchased.
Mold-Masters takes no responsibility for documentation of products or
systems if they are relocated or resold outside the intended country of
destination, as stated on the accompanying invoice and/or waybill.
1-1
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
INTRODUCTION
E-Multi Controller User Manual
To Next Page
Loading...
Need help?
General
