1.6 Copyright
© 2020 Mold-Masters (2007) Limited. All Rights Reserved. Mold-Masters
®
and the Mold-Masters logo are trademarks of Mold-Masters.
1.7 Units of Measure and Conversion Factors
NOTE
The dimensions given in this manual are from original manufacturing
drawings.
All values in this manual are in S.I. units or subdivisions of these units.
Imperial units are given in parenthesis immediately after the S.I. units.
Table 1-2 Units of Measure and Conversion Factors
Abbreviation Unit Conversion Value
bar Bar 14.5 psi
in. Inch 25.4 mm
kg Kilogram 2.205 lb
kPa Kilopascal 0.145 psi
gal Gallon 3.785 l
lb Pound 0.4536 kg
lbf Pound force 4.448 N
lbf.in. Pound force inch 0.113 Nm
l Litre 0.264 gallon
min Minute
mm Millimeter 0.03937 in.
mΩ Milli Ohm
N Newton 0.2248 lbf
Nm Newton Meter 8.851 lbf.in.
psi Pound per square inch 0.069 bar
psi Pound per square inch 6.895 kPa
rpm Revolutions per minute
s Second
°
Degree
°
C
Degree Celsius
0.556 (
°
F -32)
°
F
Degree Fahrenheit
1.8
°
C +32
1-2
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
INTRODUCTION
E-Multi Controller User Manual
To Next Page
Loading...
Need help?
General
