Mold-Masters E-Multi EM1 - E-Multi Injection Unit Safety Guards; Figure 3-4 Guards Layout

3.13 E-Multi Injection Unit Safety Guards
WARNING
Guards should not be removed unless maintenance is required and should
be replaced after maintenance is complete. Do not run the machine with
guards removed.
CAUTION
When installing the machine guards (front and rear covers) and the barrel
covers, check that they do not pinch water lines, air lines or thermocouple
wires when the unit moves.
CAUTION
Front
cover
Rear
cover
Figure 3-4 Guards layout
3-19
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
SAFETY
E-Multi Controller User Manual