3.19 E-Multi Injection Unit Stand Safety
WARNING
The stands are intended for supporting E-Multi injection units at the
machine when used in the horizontal position. They are not for transporting
the E-Multi injection unit and would be top heavy and present a tip hazard.
The E-Multi injection unit and stand assembly should be moved together by
crane using the proper E-Multi injection unit lift points.
Do not modify stands to reduce or add height, e.g. adding additional holes
or not bolting the upper and lower columns together. Such changes would
impact the stand stability and could result in serious injury as well as
damage to the machine.
3-28
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
SAFETY
E-Multi Controller User Manual
To Next Page
Loading...
