Mold-Masters E-Multi EM1 - Default Chapter; Table of Contents

Table of Contents
Section 1 - Introduction ...................................................1-1
1.1 Intended Use ......................................................................................................1-1
1.2 Release Details ..................................................................................................1-1
1.3 Warranty .............................................................................................................1-1
1.4 Returned Goods Policy ....................................................................................... 1-1
1.5 Movement or Resale of Mold-Masters Products or Systems .............................1-1
1.6 Copyright ............................................................................................................1-2
1.7 Units of Measure and Conversion Factors .........................................................1-2
1.8 Trademarks and Patents ....................................................................................1-3
Section 2 - Global Support ..............................................2-1
2.1 Manufacturing Facilities ......................................................................................2-1
2.2 Regional O󰀩ces .................................................................................................2-1
2.3 International Representatives .............................................................................2-2
Section 3 - Safety..............................................................3-1
3.1 Introduction .........................................................................................................3-1
3.2 Safety Hazards ...................................................................................................3-2
3.3 Operational Hazards ........................................................................................... 3-5
3.4 General Safety Symbols .....................................................................................3-7
3.5 Wiring Check ......................................................................................................3-8
3.6 Lockout Safety ....................................................................................................3-9
3.6.1 Electrical Lockout .....................................................................................3-10
3.6.2 Energy Forms and Lockout Guidelines....................................................3-11
3.7 Grounded Earth Connections ...........................................................................3-12
3.8 Disposal ............................................................................................................3-12
3.9 E-Multi Controller Safety Hazards ....................................................................3-13
3.9.1 Operational Environment .........................................................................3-13
3.9.2 Cabinet Push / Tip Forces .......................................................................3-13
3.10 E-Multi Injection Unit Safety Labels ................................................................3-15
3.11 E-Multi Injection Unit Safety Hazards .............................................................3-16
3.12 E-Multi Injection Unit Safety Symbols ............................................................. 3-18
3.13 E-Multi Injection Unit Safety Guards ............................................................... 3-19
3.14 E-Multi Weight Specications .........................................................................3-20
3.15 Unpack the E-Multi Controller ......................................................................... 3-21
3.16 Lift the E-Multi Controller ................................................................................3-23
3.16.1 Preparation ............................................................................................3-23
3.17 Lift the E-Multi Injection Unit ...........................................................................3-25
3.17.1 Prior to Lifting the E-Multi Injection Unit.................................................3-25
3.18 EM1 / EM2 / EM3 Lift Connections ................................................................. 3-26
3.18.1 EM1 / EM2 / EM3 Vertical Lift Connections ...........................................3-26
3.18.2 EM1 / EM2 / EM3 Horizontal Lift Connections.......................................3-27
3.19 E-Multi Injection Unit Stand Safety .................................................................3-28
i
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
E-Multi Controller User Manual