Mold-Masters E-Multi EM1 - Page 3

Section 4 - Overview ........................................................4-1
4.1 Controller Front ................................................................................................... 4-1
4.2 Controller Back - Connections Side .................................................................... 4-2
4.3 Cable Holders .....................................................................................................4-3
Section 5 - Installation .....................................................5-1
5.1 Introduction .........................................................................................................5-1
5.2 Connect the Controller to the E-Multi .................................................................5-2
5.3 Connect a Robot to the Controller ......................................................................5-2
5.4 Connect the Controller to the Molding Machine .................................................5-3
5.5 Connect a Handheld HMI (Optional) ..................................................................5-4
5.6 Connect Diagnostic Computer (Optional) ...........................................................5-4
Section 6 - Operation .......................................................6-1
6.1 Introduction .........................................................................................................6-1
6.2 Isolate the Controller ..........................................................................................6-1
6.3 Switch On ...........................................................................................................6-2
6.4 Switch O󰀨 (Shutdown) ........................................................................................6-2
6.4.1 Shutdown the Heating ...............................................................................6-2
6.4.2 Shutdown the Controller ............................................................................6-2
Section 7 - E-Multi Controller HMI Interface ...................7-1
7.1 Introduction .........................................................................................................7-1
7.2 Cabinet Mounted Control Buttons ......................................................................7-2
7.3 E-Multi Touchscreen Interface ............................................................................7-3
7.3.1 Top Bar - Status Display ............................................................................7-4
7.3.2 Active Movement Icons ..............................................................................7-5
7.3.3 Status Icons ...............................................................................................7-5
7.3.4 Bottom Bar - Screen Navigation Buttons ...................................................7-6
7.3.5 Print Functionality ......................................................................................7-7
7.4 Screen Descriptions ...........................................................................................7-8
7.5 Overview Screen ................................................................................................7-9
7.6 Injection Settings Screen ..................................................................................7-13
7.7 Hold Settings Screen ........................................................................................7-16
7.8 Recovery Settings Screen ................................................................................7-18
7.9 Barrel Temperature Settings - Legacy Controllers* ..........................................7-21
7.10 Barrel Temperature Settings - Mold-Masters Screen .....................................7-23
7.11 Integrated Hot Runner Temperature Control (Option) .....................................7-26
7.11.1 Monitor Screen .......................................................................................7-27
7.11.2 Setup Screen (Supervisor Level) ...........................................................7-31
7.11.3 Utilities Screen (Supervisor Level) .........................................................7-35
7.12 Integrated E-Drive Control (Option) ................................................................7-37
7.12.1 E-Drive Control Buttons .........................................................................7-38
7.13 Overview Screen ............................................................................................7-39
7.13.1 Homing ..................................................................................................7-40
7.14 Settings Screen (Supervisor Level) ................................................................7-41
7.15 Valve Gate Settings Screen ............................................................................7-43
7.16 Shuto󰀨-Nozzle Settings Screen ...................................................................... 7-45
7.17 7.17 Shuto󰀨-Nozzle Settings Screen—Kortec ................................................ 7-48
ii
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
E-Multi Controller User Manual