Mold-Masters E-Multi EM1 - 3.16 Lift the E-Multi Controller

3.16 Lift the E-Multi Controller
3.16.1 Preparation
WARNING
Always ensure that all lifting devices are in good repair and of adequate
capacity before commencing work. Failure to lift or support the controller
properly can result in severe injury or death and / or damage to the
controller.
1. Choose lift equipment that is rated for the prescribed load.
2. Dene the load path: the path and orientation the item will move in while
it is being lifted, and the location and orientation where it will be set down.
3. Identify and avoid potential pinch points: where an individual or a
component of the lifting equipment or load may be caught between two
surfaces.
4. Secure and remove all boxes and accessories from the crate and store in
a safe location away from the lift path.
5. Remove all cables not attached to the controller from the crate and store
in a safe location away from the lift path.
The E-Multi controller is shipped with four eyebolts with threaded studs and
four washers. These components are attached to the keys at the back of the
controller. See Figure 3-9.
Figure 3-9 Eyebolts and washers
3-23
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
SAFETY
E-Multi Controller User Manual