E-Multi Injection Unit Safety Hazards - continued
Table 3-4 E-Multi Injection Unit Safety Hazard Details
Hazard Type Potential Hazards
Hazards Generated By Materials or Substances
Hazards from Contact
With or Inhalation of
Harmful Gases
Hot material could result in harmful gases being emitted from the purged
material, feed inlet or mold.
Fire or Explosion
Hazard
Hot surfaces of the barrel heaters could ignite ammable liquids or dust.
Ergonomic Hazards
Lift Hazard Attempting to lift or support the unit during installation could result in
injury.
Combination Hazards
Failure / Disorder of
Control System
Incorrect connections can result in out-of-control or unexpected
movement causing damage to the machine and a possible hazard.
Errors of Fitting Incorrect design of the adapter plate, or tool interface or attachment, or
improper torquing of mounting fasteners may result in a failure of the
connection and subsequent loss of stability or falling of the machine.
3-17
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
SAFETY
E-Multi Controller User Manual
To Next Page
Loading...
