Mold-Masters E-Multi EM1

To Next Page

To Previous Page

Section 9 - Troubleshooting ............................................9-1

9.1 Thermocouple Electrical Check ..........................................................................9-1

9.2 Heater Continuity Check ..................................................................................... 9-1

9.3 Transducer Output Check ................................................................................... 9-1

9.4 Vibrator Valve Check ..........................................................................................9-1

9.5 Servo Motor Temperature Check ........................................................................9-2

9.6 Troubleshoot the Control System .......................................................................9-2

9.6.1 Fault and Warning Messages ....................................................................9-3

Index ......................................................................................I

Section 10 - Index .................................................................I

E-Multi Controller User Manual

Mold-Masters E-Multi EM1 - Page 5