AT Commands Alphabetical Summary
A-6 AT Commands Reference Manual December 31, 2007
+CIMI
This command requests the
International Mobile Subscriber
Identity number.
Page 3-6
+CIND
This command is used to query
the status of various ME
indicators.
Page 3-316
+CKEV
This command causes the G24 to
send an unsolicited message
when a key is pressed on the G24
keypad, and local key press echo
is enabled.
Page 3-320
+CKPD
This command emulates key
presses, or virtual keycodes, as if
entered from the G24 keypad or
from a remote handset.
Page 3-310
+CLAC
This command displays a list of
all the AT commands supported
by the G24.
Page 3-9
+CLAN
This command handles the
selection of language in the ME.
Page 3-315
+CLCC
This command returns a list of all
current G24 calls and their
statuses, and also
enables/disables the unsolicited
indication of the call list.
Page 3-47
+CLCK
This command locks, unlocks or
interrogates a G24 or a network
facility <fac>.
Page 3-259
+CLIP
This command controls the
Calling Line Identity (CLI)
presentation to the terminal when
there is an incoming call.
Page 3-21
+CLIR
This command enables/disables
the sending of caller ID
information to the called party,
for an outgoing call.
Page 3-31
+CLVL
This command sets the volume of
the internal loudspeaker (which
also affects the key feedback
tone) of the G24.
Page 3-233
+CMEE
This command enables/disables
the use of result code +CME
ERROR: <err> as an indication
of an error relating to the
functionality of the G24.
Page 3-289
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page
To Next Page
Loading...
Need help?
General
