Appendix A: Reference Tables
December 31, 2007 AT Commands Reference Manual A-19
+MTTY
This command is used to
enable/disable the TTY (Tele
Typewriter) support in the G24.
Page 3-44
+MUPB
This command causes the G24 to
send an event when a phone book
entry is accessed or modified by
the user.
Page 3-322
+MVC
This AT command is used to
choose and configure the
priority order of the supported
voice codecs (vocoders).
Page 3-43
+MVREF
This command defines the
behavior of Vref regulator.
Page 3-227
+TADIAG
This command queries actual
ADC values of the antennas.
Page 3-210
+TASW
This command controls the
antenna switch mechanism.
Page 3-209
+TCLCC
This command displays a list of
all current G24 calls and their
statuses, and also
enables/disables the unsolicited
indication of the call list.
Page 3-51
+TPIN
This command queries the
number of remaining SIM
PIN/PUK entering attempts.
Page 3-257
+TSMSRET
This command controls the SMS
sending retry.
Page 3-142
+TWUR This command is used to query
the wakeup reason(s).
Page 3-209
+TWUS This command is used to set the
wakeup reason(s).
Page 3-207
+VTD
This command handles the
selection of tone duration.
Page 3-250
+VTS
This command transmits DTMF
tones when a voice call is active.
Page 3-251
A
This command answers an
incoming call, placing the G24
into the appropriate mode, as
indicated by the RING message.
Page 3-19
A/
This command repeats the last
command entered on the
terminal.
Page 3-252
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page
To Next Page
Loading...
