Motorola G24 Guide User Manual

Chapter 1: Product Features
December 31, 2007 AT Commands Reference Manual 1-31
+CDEV An unsolicited indication regarding display changes that is sent to
the DTE when the <disp> parameter of the +CMER command is set
to 1.
Page 3-321
+CIEV An unsolicited indication regarding various phone indications that is
sent to the DTE when the <ind> parameter of the +CMER command
is set to 1.
Page 3-321
GPRS
GPRS Commands
+CGCLASS This command sets the GPRS mobile station class.
Page 3-324
+CGDCONT This command specifies the PDP (Packet Data Protocol) context.
Page 3-325
+CGQMIN This command sets the minimum acceptable quality of service
profile.
Page 3-327
+CGQREQ This command displays the requested quality of service profile.
Page 3-329
+CGACT This command activates/deactivates the PDP Context.
Page 3-330
+CGPADDR This command reads the allocated PDP addresses for the specified
context identifiers.
Page 3-336
+CGATT This command attaches the G24 to the GPRS network.
Page 3-330
D*99 This command enables the ME to perform the actions necessary for
establishing communication between the terminal and the external
PDN.
Page 3-332
+CGPRS This command indicates whether there is GPRS coverage.
Page 3-334
+MDLC This command establishes PPP link over serial port.
Page 3-337
+MIAU This command manages IP Director addresses and port.
Page 3-338
EDGE Commands
+CGEQREQ This command allows the TE to specify a EDGE Quality of Service
Profile that is used when the MT sends an Activate PDP Context
Request message to the network.
Page 3-340
+CGEQMIN This command allows the TE to specify a minimum acceptable
profile, which is checked by the MT against the negotiated profile
returned in the Activate/Modify PDP Context Accept message.
Page 3-346
+CGEQNEG This command allows the TE to retrieve the negotiated QoS profiles
returned in the Activate PDP Context Accept message.
Page 3-352
+MCEG This command disables / enables EDGE support in G24 modules
with EDGE support capability.
Page 3-356
STK Commands
+MTKR This command displays the profile that is downloaded from the G24
to the SIM during the SIM initialization process.
Page 3-358
+MTKE This command enables/disables the SIM ToolKit functionalities.
Page 3-367
Table 1-1: AT Commands (Cont.)
AT Command Description Page

Motorola G24 Guide Specifications

General

Brand	Motorola
Model	G24 Guide
Category	Telephone Accessories
Language	English