Printing in the Windows Environment 2-6
2.1 Preparation for Printing (Network Connection)
2
*2 Supports 32-bit (e86)/64-bit (e64) environment.
Installation procedure
Install the printer driver using the installer.
0 Administrator privileges are required to perform this task.
0 Use "Driver CD-ROM Vol.1" to install the PCL/PS driver on the PC, and use "Driver CD-ROM Vol.2" to
install the XPS driver on the PC.
0 The following explains the PCL/PS driver installation procedure. You can also install the XPS driver in
a similar way.
1 Insert the printer driver CD-ROM into the CD-ROM drive of the computer.
% Make sure that the installer starts, and then go to Step 2.
% If the installer does not start, open the printer driver folder on the CD-ROM, double-click [Set-
up.exe], and then go to Step 3.
% If the [User Account Control] window appears, click [Continue] or [Yes].
2 Click [Printer Install].
3 Read the license agreement and click [AGREE].
4 Select [Install printers/MFPs] and click [Next].
Connected printers are detected.
% For Windows Vista/7/Server 2008/Server 2008 R2, you can select [Preference for IPv4] or [Prefer-
ence for IPv6]. The address has the preference when detected in both IPv4 and IPv6.
5 Select this machine, then click [Next].
% If this machine is not detected, restart this machine.
% You do not need to change the printing method from [Normal Printing] (Port 9100) unless otherwise
specified by the administrator.
To Next Page
Loading...
