NARDA SRM-3006 - Setting the measurement parameters

8 Spectrum Analysis Mode
Narda SRM-3006 113
Selecting the result type
The Select Result Type softkey is used to select the result type to be used
for integration. You can only select from the result types that were
highlighted under Spectrum • Result Type.
1. Press the Select Result Type softkey.
2. Use the rotary control to select the desired result type and press the OK
key.
Setting the integration range using frequency limits
1. Press the Frequency Integration Min softkey to set the lower frequency
limit.
ª The diamond of the left marker will be filled out in black if graphical
entry is selected.
2. Use the rotary control or the keypad to specify the lower frequency limit
and then press the OK key to save the setting.
3. Softkey Frequency Integration Max softkey to set the upper frequency
limit.
ª The diamond of the right marker will be filled out in black if graphical
entry is selected.
4. Use the rotary control or the keypad to specify the upper frequency limit
and then press the OK key to save the setting.
Setting the integration range using a center frequency
and a frequency band
1. Press the Frequency Integration Cent softkey to set the center
frequency.
ª The diamond of the center marker will be filled out in black if graphical
entry is selected.
2. Use the rotary control or the keypad to specify the center frequency and
then press the OK key to save the setting.
3. Press the Frequency Integration Span softkey to set the frequency
band.
ª The diamonds of both markers will be filled out in black if graphical
entry is selected.
4. Use the rotary control or the keypad to specify the frequency band and
then press the OK key to save the setting.