17 Specifications
Narda SRM-3006 189
Isotropic Measurements Automatic switching of the antenna axes when using
Narda’s three axis measurement antenna followed by
computation of the isotropic result
Sequential measurements using single axis antennas with
subsequent computation of the isotropic result are
supported.
Both results are directly displayed as a spectrum curve or
as numerical values
Weighted Display In % of the standard for the following human safety
standards: ICNIRP, IEEE, FCC, BGV B11, BImSchV,
Safety Code 6
Updating for new human safety standards can be made
using the PC configuration software SRM-3006 Tools
(included in delivery)
Correlation of results
with telecom service
Definition and editing of service tables with the PC
configuration software SRM-3006 Tools, i.e. lists of
frequency bands (upper and lower limit frequency, name
for defined frequency band)
Storage of service tables in the basic unit
Use of the service tables for automatic correlation of
measurement results with defined services based on
frequency (marker functions, peak table evaluation
function, Safety Evaluation mode)
Setups Complete device configurations can be saved in the basic
unit; up- and downloadable using SRM-3006 Tools
software.
Measurement Routines Programmable sequences of setups
Memory Memory capacity: 128 MB
Memory modes: Result stored as ...
• Spectrum in Spectrum Analysis mode (SPECTRUM)
• Table in Safety Evaluation mode (SAFETY)
• Values for Level Recorder (LEVEL) and Scope (SCOPE)
Hold Freezes the display; the measurement continues in the
background.
To Next Page
Loading...
