3 Connecting Up and Starting to Use the Device
32 SRM-3006 Narda
Connecting the Narda cable to the SRM-3006
✓ The SRM-3006 is switched off.
1. Stand the Basic Unit up in a vertical position.
2. Place the N connector of the cable on to the N connector of the Basic
Unit.
3. Screw the coupling nut of the cable N connector slowly on to the Basic
Unit N connector taking care not to cross-thread it.
Note: If the coupling nut does not turn easily, reposition it and start again.
Approximately 4 full turns are needed to fully tighten the connection.
4. Place the control cable plug of the cable on to the multipin connector on
the Basic Unit so that the red dot on the control cable plug is aligned with
the red dot on the multipin connector.
5. Push the control cable plug into the connector using the locking sleeve
until the plug lock engages.
ª The Narda cable is connected.
The device automatically recognizes the cable type that is connected.
This information is shown in the display in the general device
configuration section while the device is switched on.
Connecting the Narda cable to the Narda antenna
✓ The SRM-3006 is switched off.
1. Place the N connector of the cable on to the N connector of the antenna.
2. Screw the coupling nut of the cable N connector slowly on to the antenna
N connector taking care not to cross-thread it.
Note: If the coupling nut does not turn easily, reposition it and start again.
Approximately 4 full turns are needed to fully tighten the connection.
3. Place the control cable connector of the cable on to the control cable
connector of the antenna so that the red dot on the control cable
connector is aligned with the red dot on the antenna control cable
connector.
4. Push the antenna control cable plug into the connector using the locking
sleeve until the plug lock engages.
ª The Narda antenna is connected.
The device automatically recognizes the antenna type that is
connected. This information is shown in the display in the general
device configuration section while the device is switched on.
To Next Page
Loading...
