3 Connecting Up and Starting to Use the Device
36 SRM-3006 Narda
1. Screw the antenna holder plate on to the tripod.
2. Screw the antenna holder on to the antenna holder plate.
3. Undo the Velcro strips and place the antenna in the holder so that the N
connector and the control cable fit into the guideway (see Figure 6 on
page 37).
4. Do up the Velcro strips.
5. Turn the antenna to the desired position (marked on the antenna holder)
and do up the screw to fix it in position.
6. Connect the antenna and the Basic Unit together using a cable (see
Connecting a Narda antenna to the Basic Unit using a Narda cable
on page 31).
NOTICE
Damage caused by spacing screws
The black coating can be damaged by the spacing screws.
⇒ When removing the antenna from the holder, slide it up in the direction
of the antenna head first before removing it from the holder.
To Next Page
Loading...
