If you want to configure MASCHINE to react to other MIDI messages than MIDI Clock,
in particular if you want to control MASCHINE notes and parameters via MIDI, please
refer to section ↑11.2, Using MIDI Control and Host Automation, where this is described
in detail.
2.7.3 Send MIDI Clock
If MASCHINE is running as a stand-alone application, it can also send a MIDI Clock signal to
any device that is capable of receiving MIDI Clock. This could be hardware such as a drum
machine, another groovebox, or even another software sequencer.
If you use MASCHINE as a plug-in, it cannot send any MIDI Clock signal. See section
↑2.5, Stand-Alone and Plug-in Mode for more information on using MASCHINE as a
plug-in.
To configure MASCHINE to receive MIDI Clock from an external device:
1. Select Preferences entry from the File menu.
2. Select the MIDI page.
3. In the Sync section select Master (Send Clock) from the menu.
→ MASCHINE will send a MIDI Clock signal to any connected device that is capable of re-
ceiving MIDI Clock.
You can adjust the MIDI Clock offset in the MIDI page of the Preferences panel. See
↑2.6.3, Preferences – MIDI Page for more information.
If you want MASCHINE to send other MIDI messages than MIDI Clock, in particular if
you want to control other MIDI-capable devices via the notes played in MASCHINE,
please refer to section ↑11.2.5, Sending MIDI from Sounds.
Basic Concepts
Integrating MASCHINE into a MIDI Setup
MASCHINE - Manual - 103
To Next Page
Loading...
