Native Instruments MASCHINE MK3 User Manual

16.5.6 Adjusting the Zone Settings
At the bottom of the Zone page, the Zone settings allow you to adjust how each Zone should be
played back.
The Zone settings in the software.
The various sections always display the values for the focused Zone.
If the MASCHINE window is not wide enough to display all Zone settings at once, a hori-
zontal bar appears underneath to scroll to the desired section of parameters.
Following parameters are available:
(1) PLAY RANGE section
The parameters in the PLAY RANGE section allow you to adjust the portion of Sample that will
be played back when the Zone is triggered.
Parameter
Description
START Adjusts the playback’s start point in the Sample of the focused
Zone.
END Adjusts the playback’s end point in the Sample of the focused
Zone.
(2) LOOP section
The parameters in the LOOP section allow you to define and adjust a portion that will play in
loop while the note is held.
Sampling and Sample Mapping
Mapping Samples to Zones
MASCHINE - Manual - 874

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs