Native Instruments MASCHINE MK3 User Manual

3. Press the corresponding pad to select a Section.
4. Press Button 3 AUTO LENGTH to enable Auto Length.
→ The selected Section is automatically resized to fit the content of the Patterns within the
assigned Scene. Any manual adjustments that were previously made are discarded.
15.3.14 Looping
Activate a Loop to repeatedly play a section of the Arrangement. Once a loop is activated the
Sections within the range of the Loop play until the loop is deactivated. You can use the range
to repeatedly play a particular part of a song. This can be good for composing, practicing a part
before recording, recording multiple takes, etc. The loop range is permanently visible, (even
when it is deactivate) and the range of the loop can be altered at any time using the left and
right end points.
15.3.14.1 Setting the Loop Range in the Software
Set the start, end and position of the loop using the dedicated Loop range in the Timeline. The
value set in the Arrange Grid is used for Loop range increments and movement of the loop
range itself.
To adjust the Loop range using the software:
► Drag the left or right end of the Loop marker to make it longer.
→ The Loop range is elongated.
To move the Loop using the software:
Working with the Arranger
Using Arranger View
MASCHINE - Manual - 802

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs