Native Instruments MASCHINE MK3 User Manual

1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
The unlabeled buttons and knobs on the MASCHINE controller.
For better reference, we applied a special formatting here: throughout the document, the ele-
ments are capitalized and numbered, so the buttons above the displays are written Button 1 to
Button 8, while the knobs under the displays are written Knob 1 to Knob 8. E.g., whenever you
see an instruction such as “Press Button 2 to open the EDIT page,” you’ll know it’s the second
button from the left above the displays.
1.3 New Features in MASCHINE 2.7
The following new features have been added to MASCHINE:
▪ Audio plug-in has been introduced. The Audio plug-in can playback audio (drums, percus-
sion, basslines, guitar riffs, etc.) in a Pattern in sync with your Project. Use in Loop mode
to repeat audio for the duration of the Patten Length, or use Gated mode to selectively
playback audio and pitch it using MIDI note events. For more information on the Audio
plug-in, refer the chapter: ↑7, Using the Audio Plug-in.
Welcome to MASCHINE
New Features in MASCHINE 2.7
MASCHINE - Manual - 27

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs