▪ Bold: ↑8.2.7, Kick – Bold.
▪ Maple: ↑8.2.8, Kick – Maple.
▪ Push: ↑8.2.9, Kick – Push.
For more information on engines, see ↑8.1.1, Engines: Many Different Drums per Drum-
synth. For general information on the Kick and the other Drumsynths, see ↑8.1, Drum-
synths – General Handling.
8.2.1 Kick – Sub
The Sub engine is the default engine of the Kick.
Based on the kick from a classic analog drum machine, the Sub kick is a clean, subby, sine-
based kick drum which can be very effectively abused as a sub bass, tom or even a bleepy lead
if tuned up and played chromatically on the keyboard.
The parameters described below are presented as they appear in the Control area (Ar-
range view). The same parameters are available in the Plug-in panel within the Plug-in
Strip (Mix view). See ↑12.4, The Plug-in Strip for more information on this.
Main Page
Element Description
MAIN Section
Engine Selects the engine used in the Kick Plug-in. If you change this
setting, please refer to ↑8.2, The Kicks.
Tune Adjusts the pitch of the drum played by the middle C, measured in
MIDI note numbers and cents. Available values range from 31.00 to
55.00. The default value is 43.00. For more details see ↑8.1.5,
Pitch Range, Tuning, and MIDI Notes.
Decay Adjusts the duration of the sound’s tail, measured as a percentage.
Available values range from 0.0 to 100.0 % (default: 50.0 %).
Using the Drumsynths
The Kicks
MASCHINE - Manual - 342
To Next Page
Loading...
Need help?
General
