16.4.5 Applying the Slicing
Once you are satisfied with the proposed and/or manually adjusted Slices (see section
↑16.4.2, Adjusting the Slicing Settings), you can apply the slicing in order to actually cut the
original Sample and create these Slices. This is done via the three elements at the bottom
right of the Slice page:
You can apply the slicing in various ways.
(1) Apply button
Exports the Slices to the same Sound. If you click Apply, the Slices will be mapped to individ-
ual notes of this Sound, the Sample Editor will be replaced by the Pattern Editor in Keyboard
view, and the pads of your controller will switch to Keyboard mode so that you can directly play
your Slices on the pads. Additionally, depending on the setting of the Pattern Creation selector
(3), some notes can be automatically created for each Slice (see below).
(2) Slice Dragger
Drag the Slice Dragger to export the Slices to any other Sound or Group:
Sampling and Sample Mapping
Slicing a Sample
MASCHINE - Manual - 853
To Next Page
Loading...
