Adjusting the Choke or Link Parameter for Multiple Sounds with different Choke or Link Values
► Click the MULTI label next to Choke or Link and select the desired value from the list to
set all selected Sounds to that same Choke or Link group, respectively. This also applies
to the Master/Slave setting next to it.
Sound slots 1 to 4 are selected. If they have different Choke values, a MULTI label appears (left). When you click it and
select a new Choke or Link group from the list (middle), this new group is applied to all selected Sounds.
This is also true when adjusting the parameter from your controller.
5.3 Adjusting the Base Key
In Group mode, the base key defines the key (or pitch) at which the selected Sound will be
played when its pad is pressed. In Keyboard mode, it defines the key played by pad 1 on your
controller; pads 2–16 will then play keys from [base key + 1 semitone] up to [base key + 15
semitones].
The base key also affects the pitch of events created via the step sequencer. See section
↑10.3.1, Step Mode Basics for more information on this.
Playing on the Controller
Adjusting the Base Key
MASCHINE - Manual - 239
To Next Page
Loading...
