Native Instruments MASCHINE MK3 - Creating and Deleting Scene Banks

4. Press the pad corresponding to the Scene you want to delete. Alternatively you can select
the Scene by pressing the Page buttons.
5. Press Button 6 (DELETE).
→ The Scene is deleted with all its Patterns. Scenes to the right shift to fill the gap.
Alternate Method
1. Press SHIFT + SCENE to enter Ideas view.
2. Press and hold SCENE (Section) to enter Scene mode.
3. Press Button 7 and 8 to select the desired Scene bank.
4. Press ERASE + the pad corresponding to the Scene you want to delete.
→ The Scene is deleted with all its Patterns. Scenes to the right shift to fill the gap.
If the desired Scene bank is already selected (or if there is only one Scene bank), this
alternate method can be simplified as follows: Press ERASE + SCENE (Section) + pad
to delete the corresponding Scene.
You can also delete Scenes in Scene Arrange mode: press ARRANGE then Button 1
(SCENE) to enter Scene Arrange mode, then follow either of the procedures described
above.
15.2.6 Creating and Deleting Scene Banks
A new Scene bank is automatically created once you fill an entire bank with Scenes.
Deleting Scene Banks using the Controller
To delete a Scene bank:
1. Press SHIFT + SCENE (Section) to enter Ideas view.
2. Press and hold SCENE (Section) to enter Scene mode.
3. Press Button 7 and 8 to select the desired Scene bank.
Working with the Arranger
Using Ideas View
MASCHINE - Manual - 767